Part Number 51233400352 – BMW Hood Lift Support

Description

Part Number 51233400352 – BMW Hood Lift Support

Used genuine BMW part for BMW X3 2004-2010

Part Number 51233400352

51-233-400-352

Fitment:

• 2004 – 2010 BMW X3 Hood Lift Support

X3 E83   (01/2003 — 07/2006)
X3 E83 LCI   (02/2006 — 08/2010)

The BMW Hood Lift Support – Part Number 51233400352 is a vital component that plays a critical role in the smooth operation of your BMW’s hood. As the lift support wears out or becomes damaged over time, it can cause the hood to be difficult to open or close, or even to stay open on its own. Additionally, this can pose a significant safety hazard while driving, as the hood may fly open and obstruct your view or cause damage to your vehicle. However, its easy to replace them.

Fortunately, replacing the lift support with Part Number 51233400352 is a simple and cost-effective solution to this problem. Designed to fit perfectly with your BMW, this lift support provides reliable and sturdy support for your hood. Otherwise you could have them fitted at your local automotive repair shop, albeit you would have to pay for their time to do so.

The installation process for the BMW Hood Lift Support – Part Number 51233400352 is relatively straightforward and can be completed with basic tools. Once installed, you’ll immediately notice a significant improvement in the ease and smoothness of opening and closing your BMW’s hood. This small but essential upgrade can make a significant difference in your overall driving experience and the functionality of your BMW.

Below, we have detailed steps to help you install the lift support properly.

Here are the steps to change the BMW Hood Lift Support:

1. Open the hood and secure it with a prop rod or have an assistant hold it up.
2. Locate the hood lift support on either side of the hood. It is a long, slender cylinder that connects the hood to the frame of the car.
3. Use a flathead screwdriver or a small pry bar to pry off the retaining clip at the bottom of the lift support. Be sure to catch the clip as it comes off so you don’t lose it.
4. Use a socket wrench to remove the bolt that connects the top of the lift support to the hood. Be careful not to drop the bolt or the lift support.
5. Remove the old lift support from the car.
6. Place the new lift support in position, aligning the holes at the top and bottom with the mounting points.
7. Reinstall the bolt that connects the top of the lift support to the hood, and tighten it securely.
8. Snap the retaining clip back into place at the bottom of the lift support.
9. Repeat these steps for the other side of the hood, if necessary.
10. Test the new lift supports by opening and closing the hood several times to ensure that they are securely attached and functioning properly.
11. Finally, remove the prop rod or have your assistant release the hood, and close it carefully.

Home