Prestige Auto Dismantlers

Home / Install guides

Guide

Fitting a used headlight

Published 22 November 2026

A headlight looks like a simple bolt-on part. On modern luxury cars it can contain bulbs or LEDs, a ballast, control modules and motors, and it has to be aimed correctly.

Before you start

This is general guidance, not a workshop manual. Follow the manufacturer's procedure for your exact car. Leave airbags and restraints, fuel systems and any high-voltage hybrid or electric systems to a qualified workshop.

Check before you fit

  • Type. Halogen, xenon (HID), LED and adaptive units are different. Match the type to your car using the VIN.
  • Beam pattern. Lights made for countries that drive on the right throw their beam differently. In New Zealand, where we drive on the left, check that the unit suits left-hand traffic or has a way to switch the beam pattern. A beam pattern for the wrong side can dazzle oncoming drivers.
  • What's included. Ballast, ignitor, bulbs, level motors and brackets differ between sellers. Ask what comes with the unit and what you have to move from your old light.
  • Condition. Check mounting lugs, lens clarity and connector pins.

Fitting

  1. Disconnect the battery. See our battery guide.
  2. Remove whatever blocks access. Depending on the car this can be the bumper cover, a grille, an undertray or an inner guard liner.
  3. Unbolt the old headlight and unplug its connectors.
  4. Move across any parts that did not come with the new one, such as the ballast or the adjusters.
  5. Fit the new unit, plug in the connectors and bolt it in. Check the gap to the bonnet and bumper before tightening everything.
  6. Reconnect the battery and test all functions.
Xenon warning

Xenon systems use very high voltage to start the lamp. Disconnect the battery, wait, and do not touch the lamp connector or ballast with the system live. Don't touch the glass of halogen bulbs with bare fingers, because skin oil shortens their life.

After fitting

  • Test low beam, high beam, indicators and any cornering or daytime lights.
  • Adaptive and levelling systems may need a calibration with a scan tool.
  • Have the aim checked. It is easy to get slightly wrong, and a poorly aimed light is both a safety and a warrant-of-fitness problem.